Create your own paper

BISE Multan · Class 12 · Physics

BISE Multan · Class 12 · Physics · 2025 · First Annual · Group 1

2025 · First Annual

Transcribed from the identified examination paper. Check the board, session and course before use. SchoolOrbit is not affiliated with the issuing board.

Objective

Source code: 4471 · Printed marks: 17 · Time: 20 Minutes

PHYSICS PAPER-II GROUP-I

OBJECTIVE

Q.No.1

You have four choices for each objective type question as A, B, C and D. The choice which you think is correct, fill that bubble in front of that question number, on bubble sheet. Use marker or pen to fill the bubbles. Cutting or filling two or more bubbles will result in zero mark in that question.

  1. 1

    The electric field created by positive point charge is:

    • (A)

      Radially outward

    • (B)

      Radially inward

    • (C)

      Circular

    • (D)

      Oblique

  2. 2

    The electric intensity due to infinite positive sheet of charge is:

    • (A)

      qεo

    • (B)

      σ2εo

    • (C)

      qA

    • (D)

      Zero

  3. 3

    In carbon resistor, the value of blue colour is:

    • (A)

      7

    • (B)

      8

    • (C)

      6

    • (D)

      9

  4. 4

    Output waveform of sweep or time base generator is:

    • (A)

      Square wave

    • (B)

      Sinusoidal wave

    • (C)

      Rectangular wave

    • (D)

      Saw tooth wave

  5. 5

    A voltmeter is always connected in circuit in:

    • (A)

      Series

    • (B)

      Parallel

    • (C)

      Perpendicular

    • (D)

      Tangent

  6. 6

    Maximum emf generated in a generator:

    • (A)

      εo=NWAB

    • (B)

      ε=NWABsin⁡θ

    • (C)

      ε=εosin⁡θ

    • (D)

      εo=εsin⁡θ

  7. 7

    A device which uses phenomenon of mutual induction:

    • (A)

      Motor

    • (B)

      Television

    • (C)

      Transformer

    • (D)

      Transistor

  8. 8

    The device which allows only the flow of D.C is:

    • (A)

      Capacitor

    • (B)

      Generator

    • (C)

      Transformer

    • (D)

      Inductor

  9. 9

    As P=Irms×Vrmscos⁡θ, in this cos⁡θ is:

    • (A)

      Gain factor

    • (B)

      Power factor

    • (C)

      Loss factor

    • (D)

      Phase factor

  10. 10

    Application of superconductor is:

    • (A)

      x-ray

    • (B)

      Microwave oven

    • (C)

      Laser

    • (D)

      MRI

  11. 11

    Transistor stand for:

    • (A)

      Transfer of resistance

    • (B)

      Transfer of charge

    • (C)

      Transfer of voltage

    • (D)

      Transfer of current

  12. 12

    A sensor of light is:

    • (A)

      Transistor

    • (B)

      LED

    • (C)

      Light dependent resistance

    • (D)

      Diode

  13. 13

    Radiation emitted by a human body at normal temperature lies in:

    • (A)

      x-rays region

    • (B)

      Ultraviolet region

    • (C)

      Visible region

    • (D)

      Infrared region

  14. 14

    The value of Plank’s constant is:

    • (A)

      6.63×10−34 Js2

    • (B)

      6.63×1034 Js

    • (C)

      6.63×1034 Js2

    • (D)

      6.63×10−34 Js

  15. 15

    Photon emitted in inner shell transition are:

    • (A)

      Energetic x-rays

    • (B)

      Characteristic x-rays

    • (C)

      Continuous x-rays

    • (D)

      Discontinuous x-rays

  16. 16

    Radiotherapy is generally done with x-rays emitted from:

    • (A)

      Strontium - 90

    • (B)

      Iodine - 131

    • (C)

      Sodium - 24

    • (D)

      Cobalt - 60

  17. 17

    The binding energy per nucleon is maximum for:

    • (A)

      Uranium

    • (B)

      Lithium

    • (C)

      Iron

    • (D)

      Oxygen

Subjective

Printed marks: 68 · Time: 2.40 Hours

INTERMEDIATE PART-II (12th Class)

PHYSICS PAPER-II GROUP-I

SUBJECTIVE

NOTE: Write same question number and its parts number on answer book, as given in the question paper.

SECTION-I

2.

Attempt any eight parts.

8×2=16

  1. (i)

    The potential is constant throughout a given region of space. Is the electric field zero or non-zero in this region? Explain.

  2. (ii)

    Electric lines of force never cross. Why?

  3. (iii)

    A particle carrying a charge of 2e falls through a potential difference of 3.0 V. Calculate the energy acquired by it in eV.

  4. (iv)

    Why the capacitance of a capacitor increase by inserting a dielectric between the plates of a capacitor?

  5. (v)

    Suppose that a charge q is moving in a uniform magnetic field with a velocity v. Why is there no work done by the magnetic force that acts on charge q?

  6. (vi)

    Why the voltmeter should have a very high resistance?

  7. (vii)

    Find the value of magnetic field that will cause a maximum force of 2.0×10−3 N on a 10 cm straight wire carrying a current of 5 A.

  8. (viii)

    Explain the right hand rule to find the direction of magnetic field inside a current carrying solenoid.

  9. (ix)

    If a nucleus has a half life of 1 year, does this mean that it will be completely decayed after 2 years? Explain.

  10. (x)

    What factors make a fusion reaction difficult to achieve?

  11. (xi)

    What are Gauge bosons? Give any two examples.

  12. (xii)

    Explain p−p reaction in sun with the help of equations.

3.

Attempt any eight parts.

8×2=16

  1. (i)

    A potential difference is applied across the ends of a copper wire. What is the effect on the drift velocity of free electrons by (i) increasing the potential difference (ii) decreasing the length and temperature of the wire

  2. (ii)

    What are the difficulties in testing whether the filament of the lighted bulb obeys Ohm’s law?

  3. (iii)

    What will be the numerical value of carbon resistance? When first, second and third bands are red, violet and orange respectively?

  4. (iv)

    How many times per second will an incandescent lamp reach maximum brilliance when connected to a 50 Hz source?

  5. (v)

    How does doubling the frequency affect the reactance of (a) an inductor (b) a capacitor?

  6. (vi)

    A sinusoidal current has peak value of 14.14 A. What will be its rms value?

  7. (vii)

    What is meant by para, dia and ferromagnetic substance?

  8. (viii)

    What is doping? With doping, resistance of semiconductor increases or decreases.

  9. (ix)

    Explain forbidden energy gap.

  10. (x)

    Why a photo diode is operated in reverse biased state?

  11. (xi)

    Why charge carriers are not present in the depletion region?

  12. (xii)

    Write Boolean expression and truth table of exclusive-NOR gate.

4.

Attempt any six parts.

6×2=12

  1. (i)

    Differentiate between mutual induction and mutual inductance.

  2. (ii)

    Define energy density in case of inductor and write its formula.

  3. (iii)

    Does the induced emf in a circuit depend on the resistance of the circuit? Does the induced current depend on the resistance of the circuit?

  4. (iv)

    Differentiate between inertial frame of reference and non-inertial frame of reference.

  5. (v)

    Draw the characteristic curves of photocurrent versus applied voltage for light of different frequencies.

  6. (vi)

    Will bright light eject more electrons from a metal surface than dimmer light of the same colour?

  7. (vii)

    Why don’t we observe a Compton effect with visible light?

  8. (viii)

    What are biological effects of X-rays?

  9. (ix)

    Is energy conserved when an atom emits a photon of light?

SECTION-II

NOTE: Attempt any three questions.

3×8=24

  1. 5.
  2. (a)

    Discuss the charging and discharging of a capacitor in detail.

    (05)
  3. (b)

    A charge of 90 C passes through a wire in 1 hour and 15 minutes. What is the current in the wire?

    (03)
  4. 6.
  5. (a)

    Derive the relation for the energy stored in an inductor in terms of magnetic field strength.

    (05)
  6. (b)

    A power line 10.0 m high carries a current 200 A. Find the magnetic field of the wire at the ground.

    (03)
  7. 7.
  8. (a)

    Define p-n Junction. How does p-n junction work in forward biased and reverse biased?

    (05)
  9. (b)

    A 10 mH, 20 Ω coil is connected across 240 V and 180π Hz source. How much power does it dissipate?

    (03)
  10. 8.
  11. (a)

    What is wave nature of particles? How Davisson and Germer experiment confirmed it?

    (05)
  12. (b)

    A 1.0 m long copper wire is subjected to stretching force and its length increased by 20 cm. Calculate the tensile strain and percent elongation which the wire undergoes?

    (03)
  13. 9.
  14. (a)

    Explain in detail the nuclear fission and fission chain reaction.

    (05)
  15. (b)

    What is the energy in eV of quanta of wavelength, λ=400 nm?

    (03)
Original source references (5)

The original files and numbering are retained. Equivalent files do not repeat the questions above.

  • Objective · 4471 · Printed marks: 17 · Time: 20 Minutes
  • Objective · 4473 · Printed marks: 17 · Time: 20 Minutes : same questions, source numbering preserved separately
  • Objective · 4475 · Printed marks: 17 · Time: 20 Minutes : same questions, source numbering preserved separately
  • Objective · 4477 · Printed marks: 17 · Time: 20 Minutes : same questions, source numbering preserved separately
  • Subjective · psp_7b4f6a083f87522f19882184084b2b23 · Printed marks: 68 · Time: 2.40 Hours